- 8 -
Command Radio Model Target Selection
PRG TX RX SCN D CMND
home channel
T32 N4 G7
PRG TX RX SCN D CMND
PROG|D/GPH-CMD
GROUP 01
When using a DPH-CMD or GPH-CMD
radio as a cloning source you must
designate the target as a G/DPH-CMD not
a standard G/DPH. Press and hold the [
*
]
key to select “PRG | D/GPH”.
NOTE: The KNG will refuse the clone if
PRG|D/GPH-CMD is not selected
Cloneable Information
Cloning Information
A KNG Source Radio sends only information the Target Radio requires.
For example, digital settings such as Network Access Codes will not be
transferred to analog only models like the GPH.
Channel Capacity Considerations
When a KNG Source zone is programmed with less channels than a
Legacy Target radio, channels about the highest programmed Source
channel will be set to inactive.
A KNG Target zone will assume the channel structure of the Source
radio. Example: Cloning from a DPHX5102X will enable sixteen channels
in the targeted KNG. Cloning from a KNG with a five channel zone will
enable only five channels in the target radio.
KNG radios do not allow a receive frequency of 0. When a Legacy
Source radio channel has no programmed receive frequency, the KNG
Target will substitute 136MHz.
Picklist Capable Target Radio Considerations
If picklist selections are assigned in the source radio, and the target
radio is capable of picklist selections, the associated picklist reference
will be cloned to the target radio. For example, if a channel has a picklist
selection of Tone 3 then a picklist reference of 3 will be sent to the target
radio and the target radio will use the value stored in the 3 position of the
radios picklist. The target radio picklists will not be affected.