- 1 -
Introduction
The KAA0701 Cloning Cable offers radio users to ability to share
programmed information between KNG portable and mobile radios and/
or other BK Radio legacy models.
Operation
The Source radio is a radio programmed with the desired radio
frequencies and settings you wish to transfer to another radio of the
same frequency range.
In order to clone radio information the Source radio must have a menu
item programmed, via PC Radio Editor, to allow cloning. (Refer to the
“Menus/Controls” section of the radio editor.)
The radio receiving the program is referred to as the Target.
Target radios can be programmed to block incoming cloning information
on a zone by zone basis.
The KAA0701 Cloning Cable requires the use of a KNG or KNG-S model
as either the Source or Target radio.
KNG as Source Radio
Connect the KAA0701 Cloning Cable to the side connector of the Source
and Target radios and power up both radios.
NOTE: Insure that all scan functions are turned off prior to cloning.
MOBILE NOTE: Microphone must be attached at power-up prior to cloning.
BK RADIO
Cha
Sec
155
MON
1
2
5
8
4
7
3
6
9
FCN
PRI
ENT
CLR
0
*
#
Digital
Ch 1
KNG - P25
171.5850 0 MHz
LIGT T/A MENU LCK
RXD
1: Scan List
2: Cloning
3: Unit Call
ESC ▲ ▼ ENT
KNG
BK RADIO
KNG
BK RADIO
KNG
Source
KNG
Target
Legacy
Target
KNG Mobile
Target
