- 2 -
On the source radio select the zone with the information to be cloned by
pressing the Zone button, or selecting “Zone Select” from the menu, then
entering the number of the desired zone.
On the target radio select the Zone or Group to which the information is
to be sent.
For Legacy radio models select a target group by pressing the [#] key
and entering the number of the desired group.
Some zones may be blocked by PC programming to prevent them from
being overwritten. Only unlocked groups will accept incoming clones.
Sending Information
Cloning in
Progress
1: Talkaround
2: Tx Power
3: Cloning
ESC ▲ ▼ ENT
Source Clone
Complete
Ch 1
KNG - P25
171.5850 0 MHz
RXD SCN
ZONE TXAD T/A MENU
On the source radio:
Press the Menu button.
1.
Use the up/down buttons to select
2.
“Cloning”.
Press the [ENT] button to send the
3.
cloning information.
While sending information “Cloning in
Progress” will be shown on the source
radio display.
After successful radio data transfer,
“Source Clone Complete” is briefly
displayed on the source radio.
Receiving Information
Cloning Mode
Destination Clone
Start
KNG Target
Target radios display a message to
indicate receiving incoming information.
KNG portable and mobile target radios
display “Destination Clone Start” during
the cloning process.
