- 5 -
KNG-S to KNG-S Instructions
Connect the KAA0701 Cloning Cable to the side connector of the Source
and Target radios and power up both radios.
Cloning Mode
Dest, Zone
→
Zone 1
Zone 2
ESC ▲ ▼ ENT
Source Zone
Zone 1
Zone L abel
ESC ▲ ▼ ENT
Zone-to-Zone
Successfully
Cloned
ESC ▲ ▼ ENT
Talkaround
Tx Power
Cloning
ESC ▲ ▼ ENT
Clone
Ac tive Zone
Zone - to -Zone
ESC ▲ ▼ ENT
Ch 1
KNG - P25
171.5850 0 MHz
LIGT T/A MENU LCK
RXD SCN
On the Source radio:
Press the Menu button.
1.
Use the up/down buttons to select
2.
“Cloning”.
Press the [ENT] button.
3.
Use the up/down buttons to select the
4.
cloning type.
Press the Enter button to send the
5.
cloning information.
The following additional steps are required
for Zone-to-Zone cloning:
Use the up/down buttons to select the
a.
desired Source radio zone.
Press the Enter button.
b.
Use the up/down buttons to select the
c.
desired Target radio zone.
Press the Enter button to send the
d.
cloning information.
While sending or receiving information
“Cloning Mode” will be shown on the
Target radio display.
Cloning Mode
Zone-to-Zone
Successfully
Cloned
ESC ▲ ▼ ENT
Clone Failed:
Target Zone
Locked
ESC ▲ ▼ ENT
After a successful information transfer,
“Cloning Successful” is displayed on the
Source radio before reverting to Send
Clone mode.
If the cloning process fails or the Target
radio’s zone is blocked form accepting
an incoming clone, a failure message will
appear on the Source radio.
