- 1 -
Operation
The BKR0700 Cloning Cable offers radio users the ability to share
programmed information between BKR portable radios.
For BKR portable radio cloning, one BKR0700 Cloning Cable is to be
connected to to a Source BKR portable radio and a Target BKR portable
radio as shown below:
SOURCE
BKR
Cloning in
Progress
Destination Clone
Mode
Waiting...
BKR0700
TARGET
BKR
The Source radio is a radio programmed with the desired radio
frequencies and settings you wish to transfer to another radio of the
same frequency range.
The Target radio is the radio receiving the frequencies and settings.
Target radios can be programmed to block incoming cloning information
on a zone by zone basis.
In order to clone radio information, the Source radio and Target radio
must have a menu item programmed, via Radio Editor Software (RES),
to allow cloning. (Refer to the “Menus/Controls” section of the radio
editor.)
