HSS Hot Food Merchandiser
Installation
CS-TM-003.01
Revised 10/01/18
7
END KICK PLATES
FIT BEHIND FRONT
KICK PLATES
RAISE
LOWER
BEFORE LEVELING -
SLIDE KICK PLATES,
ENDS FIRST, BETWEEN
BASE FRAME & OUTER
PANELS.
SECURE IN RAISED
POSITION WITH TAPE.
DRILL FRAME 9/64"
TO MATCH HOLES
IN KICK PLATES
SECURE with SCR355
#8x1/2" BLACK SCREWS
SEAL KICK PLATES TO
FLOOR with SILICONE
Installation
Serious injury, equipment damage or death could result if attempting to install this
unit yourself. Ensure that an authorized
BKI
service agent install the unit.
Move the unit as close as possible to its permanent location before moving it off of the shipping pallet. Make certain there
are no separately packed accessories before discarding packaging material.
Floor Model
Follow the procedure below to level the unit and mount the kick plates.
1. Slide kick plates,
ends first, between
the base frame and
outer panels. Secure
in raised position with
tape. Make sure that
the end kick plates fit
behind the front and
rear kick plates.
2. Using a carpenter’s
level on the lowest
shelf, level the unit by
adjusting the leg
levelers at the
corners of the unit.
Raise the low end of
the unit to level it, do
not lower the high
end. Check for level
side-to-side and front-
to-back.
3. Remove the tape
from the kick plates
and make certain that
the kick plates are
flush to the floor.
4. Drill 9/64” [3.5 mm]
diameter holes in the
base frame to match
the pre-drilled holes
in the kick plates.
5. Attach the kick plates
to the base frame
with the #8x1/2” black
sheet metal screws
provided (SCR355).
6. Seal kick plates to
floor using a silicone-
type sealant (Dow
Corning RTV #732 or
equivalent).
Figure 1.
Floor Model – Leveling & Kick Plate Mounting
