Installation Manual
Fingerprint scanner and code keypad
3.6.2 Displays and operating elements (FMIO)
S1
Push-button
Pairing push-button
L1
LED yellow
Status of control input
On: control signal is
present
L2
LED red
Status of configurable
output 2
On: output active
L3
LED
green/yellow/red
Display of radio signal
strength
L4
LED yellow
Operation indicator
On: operation
L5
LED red
Radio
On: radio control active
L6
LED yellow
Door bus
On: bus error
Flashing: door bus
active
L7
LED red
Status of output 1
On: output active
3.6.3 Pairing (FMIO)
Once a module has been connected to the FMIO, the so-
called "pairing" occurs. From this point onwards no other
module can be operated at the same FMIO. If this is
necessary, the pairing can be reset. The housing cover
must be opened to do this. Disconnect the module from
the bus. Insert the jumper next to the terminal 51 41 61.
Now press push-button S1 until an acoustic signal is
heard. The pairing information has been deleted.
If you wish to reset the pairing between the radio-
controlled lock and FMIO, the jumper must not be
plugged in. In this case press and hold down S1 to reset
the pairing information of the radio-controlled lock.
Installation Manual, edition 3 dated 02/01/2013
Page 38
Copyright © BKS GmbH, 2012. All rights reserved.
C 59 501 107