www.bkte.pl
AL200 swinghandle manual
11
4.3
Adding new user card
The procedure saves to the memory the user card that will be able to open the handle.
Action
State after performing the action
1 Check if the user card has already been saved in the memory. Touching an unsaved card to the
reader should cause the red LED to flash once.
2 Touch the master card to the reader. The green LED should start blinking (2Hz) for 5 seconds.
3 While the green LED is blinking, apply a new user card.
Correct programming of the user card will be signalled by the green LED lighting for 2 seconds.
If the red LED lights up for 2 seconds, it means that the user card memory is full. You must then
remove a single card (see chapter 4.4 Removing user card) or delete all saved cards (see chapter
4.5 Removing all user cards).
4.4
Removing user card
The procedure removes a single user card from memory. The removed card will not open the handle.
Action
State after performing the action
1 Check if the user card is already saved in the memory. Touching the written card to the reader
should open the handle.
2 Touch the master card to the reader. The green LED should start blinking (2Hz) for 5 seconds.
3 While the green LED is blinking, touch the card to be removed from memory.
4 Make sure the card does not open the handle anymore - the red LED should flash once.
4.5
Removing all user cards
To remove all user cards, use the master card programming procedure (see chapter 4.2 Master card programming).
