www.bkte.pl
AL200 swinghandle manual
8
3.5
Connectors
The handle has two connectors: 8-pin and 4-pin. The 8-pin connector is the basic connector that provides power and control signals for the
handle. The 4-pin connector is dedicated only to the optional card reader. The table below describes the individual pins of the connectors. The
given colours apply to the LiYY type cable, eg AW285 and AW240 (see chapter 6 Accessories).
Connectors
8-pin socket type 53047-0810
1
GND
Power supply input: GND.
2
+12V
Power supply input: +12V.
3
STATUS
Open collector output for signalling the position of
the handle, I
C
=50mA, U
CE
=25V.
Handle open -> transistor on,
handle closed -> transistor off.
4
CTRL
Input for controlling the swinghandle from an
external system.
Opening the handle -> CTRL shorted to GND or +12V,
Closing the handle -> CTRL not connected.
5
SENSOR
Door sensor input
- for the future use. Do not connect.
6
GND
GND - for the door sensor
- for the future use. Do not connect.
7
CANL
CAN bus interface (CANL)
- for the future use. Do not connect.
8
CANH
CAN bus interface (CANH)
- for the future use. Do not connect.
4-pin socket type 53047-0410 for rfid card reader
1
GND
Card reader power supply output
(directly connected to GND of 8-pin socket).
2
+12V
Card reader power supply output
(directly connected to +12V of 8-pin socket).
3
WIEGAND 0
Wiegand 0 card reader input.
4
WIEGAND 1
Wiegand 1 card reader input.
white
brown
green
yellow
grey
pink
blue
red
4-pin socket
8-pin socket
AW240 cable
AW285 cable
white
brown
green
yellow
white-brown
brown
white-green
green
blue
white-blue
orange
white-orange
8-pin socket
UTP AW205
cable