13 - ENG
N003333
S
WARNING: Always wear certified
safety equipment: ANSI Z87.1 eye
protection (CAN/CSA Z94.3) with
side shields when removing carbon
deposits.
Drain Carburetor Bowl (Fig. 1)
1. Place the fuel valve lever (J) in the
closed position.
2. Place
an
OSHA-ap proved con tain er
suitable for fuel under the carburetor
bowl (M).
NOTE:
Using a funnel
will allow the fuel to flow into the
container with less spillage.
3. Remove the carburetor bowl drain
(L).
4. Fuel will drain from carburetor
bowl.
5. When drained, replace carburetor
bowl drain.
Cleaning Debris Screen (Fig. 1)
WARNING:
Risk of explosion
or fire. Gasoline vapor is highly
flammable. Refuel outdoors only in
well-ventilated areas. Do not refuel or
check gasoline level while the engine
is running. Do not store, spill, or use
gasoline near an open flame, a source
of sparks (such as welding), or near
operating electrical equipment.
N
A
1. Remove fuel cap (A).
2. Remove debris screen (N).
3. Clean debris screen.
Use
compressed air to blow off debris.
WARNING: When using
compressed air, user always must
wear eye protection that conforms
to ANSI Z87.1. (CAN/CSA Z94.3).
4. Replace debris screen and fuel
cap.
