14 • ENGLISH
caution are factors which cannot be built into this product,
but must be supplied by the operator.
ELECTRIC SAFETY INSTRUCTIONS
FOR POWER SUPPLY
In order to comply with the safety requirements set forth in
several international publications, the following measures
must be followed when using this unit:
1. The maximum room temperature around the power
supply must not exceed the one indicated on its label.
2. When connecting the unit to the electric supply and
to the equipment, respectively, you must check if the
voltage is the same indicated in the unit.
3. The consumption of the equipment connected to the
source output must not exceed the one indicated in
the unit.
4. This product can be used for outdoor, just make sure
not make it wet.
5. If the power supply cable is damaged, it must be fixed
by the supplier, by its representative or by qualified
personnel to avoid danger.
6. If the unit was hit and it is noticed any damage in the
protection cover or failures, the unit must not be used
and must be fixed exclusively by technically qualified
personnel assigned by the product importer and/or
legal representative.
7. The equipment must be connected to a visible and
easy access socket.
8. This product is not a toy. It is not intended for use
by children under 8 years.
IMPORTANT SAFETY PRECAUTIONS
Note:
There is a replaceable 10A glass fuse in the
cigarette lighter adapter. Replace a blown fuse by gently
unscrewing the tip of the lighter plug and inserting in a new
one of comparable Amperes rating. Do Not replace fuse
with a higher amp rated fuse.
f
Do not immerse the cooler/warmer 12V plug in water.
f
Do not insert foreign objects into the cooler/warmer
vent openings.The ventilation openings should not
be covered at any time while the cooler/warmer
is operating.
f
Do not use the cooler/warmer in the open air when
it is raining or snowing; it is not designed to be
waterproof.
f
Do not place cooler/warmer near heat sources:
heating vents, radiators, sunlight and/or any other
sources of heat.
f
Do not use the cooler/heater in the presence of
flammable fumes or gases, such as propane.
f
Do not use for cooking.
f
Do not use for medical reasons or storage of
medicine.
f
Do not operate the cooler/warmer if it has received
a sharp blow, been dropped or otherwise damaged
in any way.
f
Do not place liquids or foods in direct contact with
this unit.
f
Keep out of reach of children. The interior
becomes very hot or cold and could cause injury.
Labels on tool
FEATURE (Fig. A)
1. Handle
2. Handle grip
3. Outer lid
4. Inner lid
5. Internal fan
6. Main body
7. Inside case
8. Extra tray
9. Control Panel
10. Front soft bag
11. Side small bag
12. Side small bag
13. DC power cord
14. Ventilator
15. DC socket
16. DC switch
17. Hot/Cold switch
18. Red LED indicating Hot
19. Green LED indicating Cold
Read
Instructions
Manual
Use
Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
Hz ....... Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
n
0
....... No-Load
Speed
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
Attention! Do not Pull out the cord to disconnect the unit from a
wall outlet. hold the plug when disconnecting, pulling the
power cord may cause an electric shock.
Please disconnect the plug from the wall outlet when the unit
is not in use. Constant connection to the power source may
cause the isolator to age and may lead to electric shock or fire.
Do not put electrical appliances inside the storage
compartment of the unit.
To avoid the electric shock, do not spill any liquid on the
surface of the unit when using. And do not disconnect plug
from outlet with wet hand.
Non-qualified people are not allowed to re-model, dismantle or
repair the unit prinately.
(For AC120V type only) To reduce the risk of electric shock,
this unit has a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only one way. If still
does not fit, contact a qualitied electrician to install the proper
outlet. Do not change the plug in any way.
