6
ENGLISH
Drilling in wood
Holes in wood can be made with the same twist drill bits used
for metal or with spade bits. These bits should be sharp and
should be pulled out frequently when drilling to clear chips
from the flutes.
Drilling in metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The cutting
lubricants that work best are sulfurized cutting oil or lard oil.
Screwdriving
Always use the correct type and size of screwdriver bit.
If screws are difficult to tighten, try applying a small
amount of washing liquid or soap as a lubricant.
Always hold the tool and screwdriver bit in a straight line
with the screw
Troubleshooting
Problem
Possible cause
Possible solution
Unit will not start.
Battery pack not
charged.
Check battery pack
charging requirements
Battery pack will not
charge.
Charger not
plugged in.
Plug charger into a
working outlet.
Surrounding air
temperature too hot
or too cold.
Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (45ºC) or below
105 degrees F (+40.5ºC)
Unit shuts off abruptly.
Battery pack
has reached its
maximum thermal
limit.
Allow battery pack to cool
down.
Out of charge. (To
maximize the life of
the battery pack it is
designed to shutoff
abruptly when the
charge is depleted
Place on charger and
allow to charge.
Accessories
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning!
Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
from the interior.
Protecting the environment.
Separate collection. This product must not be
disposed of with normal household waste.
needs replacement, or if it is of no further use to you, do
not dispose of it with household waste. Make this product
available for separate collection.
z
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials.
Service Information
BLACK+DECKER offers a full network of company-owned and
authorized service locations throughtout Asia. All BLACK
+DECKER Service Centers are staffed with trained personnel
to provide customers with efficient and reliable product
service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the BLACK+DECKER
location nearest to you.
NOTE
BLACK+DECKER's policy is one of continuous
improvement to our products and, as such, we reserve the
right to change product specifications without prior notice.
Standard equipment and accessories may vary by country.
Product specifications may differ by country.
Complete product range may not be available in all
countries.
Contact your local BLACK+DECKER dealers for range
availability.
Batteries
There are no user servicable parts inside.
At the end of your products life return the whole unit
to your service agent or to a local recycling station to
have the battery recycled. Do not throw the unit out with
household waste.
