5
CUTTING LAMINATES
• Use a downward cutting blade. Cut thin laminates with the back surface facing up, as
splintering is most likely to occur on the side of the workpiece facing the saw shoe.
• For clean cuts, clamp a piece of plywood or hardboard to both sides of the laminate and cut
through the resulting sandwich.
TROUBLESHOOTING
Problem Possible Cause
Possible Solution
• Unit will not start.
• Attachment is not secured.
• Make certain the attachment is fully
pushed
into
the
Power
Unit.
For assistance with your product, visit our website
www.blackanddecker.com
for the location
of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
NOTE:
Refer to Power Unit instruction manual for troubleshooting solutions regarding operation
of the Power Unit.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous.
Recommended accessories for use with your tool are available from your local dealer or authorized
service center. If you need assistance regarding accessories, please call: 1-800-544-6986.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This Class B digital
apparatus complies with Canadian ICES-003.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers with
efficient and reliable power tool service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the Black & Decker location nearest you. To find your local
service location, refer to the yellow page directory under “Tools—Electric” or call:
1-800-544-6986
or visit www.blackanddecker.com
