Black & Decker BDH1720SM, Instruction Manual

ATTAChINg A CLeANINg PAD - fig. D

Replacement cleaning pads are available from 

your Black & Decker dealer (cat. no. SMP20).

•  Place a micro-fiber cleaning pad (6) on the 

floor with the ‘hook & loop’ side facing up.

•  Raise the steam mop off the resting mat 

(7) and press it down onto the cleaning pad 

(6). You are now ready to steam clean and 

sanitize your floor.

NOTICe:

Always place the steam mop on 

the resting mat (7) with the handle (4) in the 

upright position when stationary and make sure 

the steam mop is turned off when not in use.

ReMOvINg A CLeANINg PAD - fig. e

CAUTION:

Always wear suitable shoes 

when changing the cleaning pad on your 

steam mop. Do not wear slippers or  

open-toed footwear.

•  Return the handle (4) to the upright position 

and turn the steam mop ‘OFF’.

•  Place the steam mop on the resting mat and 

wait until it cools down. (approximately five 

minutes)

•  Place the front of your shoe onto the cleaning 

pad removal tab (13) and press down firmly.

•  Lift the steam mop up off the cleaning pad.

NOTICe:

Always place the steam mop on the resting mat (7) with the handle (4) in the  

upright position when stationary and make sure the steam mop is turned off when not in use.

fILLINg The WATeR TANk - fig. f & g

This Steam Mop incorporates an anti-calcium system to help prolong the life of the system.

NOTICe:

 The water tank is conveniently 

removable for easier use.

NOTICe:

 Fill the water tank with regular 

tap water.

NOTICe:

 In areas of very hard water, the 

use of de-ionized water is recommended.

WARNINg:

Do not overfill the tank. 

Only fill to bottom of hole with water tank in 

vertical position.

•  Ensure that the appliance is switched off 

and the power cord is disconnected from the 

power supply.

•  Place the steam mop on the resting mat (7) 

with the handle (4) in the upright position.

•  Remove the water tank (3) by pulling it 

upwards.

•  Open the filler cap (14) by lifting it up.

•  Fill the water tank (3) with water to the bottom 

of the hole with tank in vertical position.

•  Close the filler cap (14).

•  Re-install the water tank onto the steam 

mop body (11) and ensure it is firmly seated.

NOTICe:

Always empty the water tank 

after use.

5

f

g

D

e