Page 7
INSTALLATION GUIDE
When you open the box, you should have received:
Portable dehumidifier
User Guide
Castors (4)
Continuous Drain Kit
If you purchased a model with a pump (BDT50PWTB) there will be an additional
pump drain kit
To Install Castors:
1. For the 20 pint model (BDT20WTB) and the 30 pint model (BDT30WTB)
gently lift the lid of the bucket (see fig 1).
For the 40 pint model (BDT40WTB) and the 50 pint models (BDT50WTB,
BDT50PWTB) gently lift off the lid of the bucket (see fig 2). Do not pull on handle.
2. Tilt the dehumidifier no more than
45 degrees and push to insert the castors
into the base of the unit. Make sure the ring
around the castor is flush against the
bottom of the dehumidifier. (see fig. 3).
SET UP & USE
Fig. 2
Fig. 3
Fig. 1
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Castors and
other accessories
DET
Castors and
other accessories
Summary of Contents for BDT20WTB
Page 21: ...Page 21 ...