Page 7
ENGLISH
SET UP & USE
QUICK START GUIDE
Default settings can be changed. See USING THE CONTROL PANEL section for more
details.
1.
Add HE detergent to the detergent dispenser according to detergent
manufacturer’s instructions. HE detergent pods can be added to the wash tub
before adding clothes.
Add optional pre-wash and/or fabric softener to the detergent dispenser.
2. Load clothing, maximum
¾
full.
3.
Close the Door.
NOTE:
Unit will not start with the door open
.
4. Press ON/OFF to power on the unit.
5.
Turn the selector dial to a cycle such as NORMAL/COTTON.
Defaults are set for each wash cycle. These default settings can be changed on
the control panel.
6.
Press the Start/Pause button.
For more details on cycles and default setting refer to the wash program chart.
Before First Use
Before washing clothes for the fi
rst time, the washing machine should be operated
without clothing added.
1.
Connect power source and water supply.
2.
Put a small amount of detergent into the dispenser and close the dispenser.
3.
Close the Door.
4. Select a wash cycle using the dial.
5.
Press ON/OFF.
6.
Press the Start/Pause button.
NOTE:
If water leaks while water is being supplied or drained, check the water
connections.
If the washer rocks and vibrates excessively, level your washer again.
During rinse cycle when washer is spinning at a very high speed, some
vibration is normal.
NOTE:
For best performance do not load the tub more than
¾
full of dry clothes. DO
NOT OVERLOAD.
