39
ENGLISH
Note:
If wheels are not located at the same height, it will
result in an uneven cut.
Note:
It may be simpler to adjust the height of your mower
deck if the string trimmer is not attached.
Storage
Your mower deck can be hung on a wall for easy storage
(Fig. I).
1. Secure a nail or screw in a wall at your desired location.
2. Hang the mower deck on the nail or screw by the hook
5
located under the release lever
3
.
MAINTENANCE
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning. Your charger does not
require any maintenance apart from regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn off the tool and disconnect it from
the power source before making adjustments or
removing / installing devices or accessories
. An
accidental start could cause injuries.
• Switch off and unplug the machine/tool.
• Or switch off and remove the battery from the machine/
tool if the machine/tool has a separatebattery pack.
• Or run the battery down completely if it is integral and
then switch off.
• Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
• Regularly clean the ventilation slots in your tool/
machine and charger using a soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
• Regularly clean the cutting line and spool using a soft
brush or dry cloth.
• Regularly use a blunt scraper to remove grass and dirt
from the underneath of the guard.
¡Important!
To ensure product
SAFETY
and
RELIABILITY
, repairs, maintenance and adjustment
(other than those listed in this manual) should be
performed by authorized service centers or other
qualified organizations, always using identical replacement
parts. Unit contains no user service able parts inside.
CLEANING
WARNING:
Blow dirt and dust from all ventilation
ducts with dry air, at least once a week. To reduce
the risk of injury, always use ansi z87.1 Approved eye
protection when performing this task.
WARNING:
Never use solvents or other abrasive
chemicals to clean non-metallic parts of the tool. These
chemicals can weaken the plastic materials used in these
parts. Use a cloth dampened only with water and neutral
soap. Never allow liquid to penetrate inside the tool or
immerse any of the parts in a liquid.
ACCESSORIES
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
WARNING!
The use of any accessory not recommended
for use with this tool could be hazardous.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste. Should
you find one day that your BLACK+DECKER product
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make
this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
TECHNICAL DATA
TRIMMER/EDGER
MTE912
TYPE
AR
B2C
B3
B2
BR
Input
voltage
V
220 220 120 220 127
Frequency
Hz
50
50
60
60
60
Power
W
800
No-load
speed
.../min
(rpm)
7200 / 8200
Weight
(tool only)
lbs (kg)
10,2 (4,6)
MOWER DECK
CM100
Weight
lbs (kg)
4,6 (2,1)
