ENGLISH
(Original instructions)
7
Installing the Battery
WARNING: Danger of explosion if battery is
incorrectly replaced.
WARNING: DO NOT INGEST BATTERY;
CHEMICAL BURN HAZARD. This product contains
a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
♦
Keep new and used batteries away from children.
If the battery compartment does not close
securely, stop using the product and keep it away
from children.
♦
If you think batteries might have been swallowed
or placed inside any part of the body, seek
immediate medical attention.
♦
If the coin cell battery contents come into contact
with the skin, immediately wash area with mild
soap and water. If coin cell battery liquid gets
into the eye, rinse water over the open eye for
15 minutes or until irritation ceases. If medical
attention is needed, the battery electrolyte is
composed of an organic solvent and lithium salts.
♦
Do not incinerate or dispose of tool together with
household waste material! Tool that has reached
the end of its life must be collected separately
and returned to an environmentally compatible
recycling facility.
To Begin Using Your Fan
♦
Start by installing the battery.
♦
To install the battery, first detach the battery cover
from the remote. To do this, place a thumb or
small object on the grooved area on the underside
of the battery cover and push it gently to the side,
while simultaneously pulling the compartment
away from the body of the remote.
♦
Insert 1 x CR2032 battery into the battery
compartment, taking care to ensure the positive
polarity is facing upwards.
♦
Once the battery is in place, slide the battery
cover back into the remote. It will automatically
lock into place and secure the battery inside.
Installing the Wheels
♦
To prepare the air cooler for use, start by installing
the wheels.
♦
To install the wheels, first place the unit on a
stable surface and turn it upside down.
♦
Once the unit is upside down, locate the four
holes on each corner of the base. Insert each of
the four castors into one of these holes and thread
them clockwise to tighten and secure them into
place. Ensure each castor is firmly secured into
place before attempting to use the unit.
♦
Once all four castors have been securely fitted
into place, turn the unit right-side up.
♦
The unit is now ready for normal use.
Turning Your Appliance On or Off
♦
To turn the unit on, begin by plugging it into the
mains. There will be a sound prompt to indicate
the unit has been powered up.
♦
Once the unit has been plugged into the mains,
press the On/Off button on the remote control or
the unit’s control panel to turn the unit on. The
unit’s LCD screen and indicators will come on to
show the unit has been turned on.
♦
Press this button again while the fan is in
operation to put it into standby mode. The unit’s
LCD screen and indicators will go out, but the On/
Off indicator will remain lit to show the unit is in
Standby mode.
