ENGLISH
(Original instructions)
7
Electrical safety
WARNING: Before use, check that the mains
voltage corresponds to the voltage on the rating
plate.
Always check that the mains voltage
corresponds to the voltage on the rating
plate..
♦
Appliance plugs must match the outlet. Never
modify the plug in any way.
♦
Do not use any adapter plugs with this appliance.
Unmodified plugs and matching outlets will reduce
the risk of electric shock.
♦
To avoid the risk of electric shock, do not immerse
the cord, plug or appliance in water or other liquid.
Extension cables
♦
Up to 30m (100 ft) can be used without loss of
power.
♦
If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to avoid
a hazard.
Labels on Appliance
The following pictograms along with the date code
are shown on the appliance:
WARNING: Hot surface
WARNING: Do not cover
WARNING:
Before assembling, switch the
appliance off and remove the plug from the socket.
Features
1.
Control Panel
2.
Colour-changing LED strip
3.
Air outlet
4.
Protective mesh
5.
Air inlet
6.
Base
7.
Tip-over switch
Use
About the Controls
♦
9-hour timer
♦
2 Heat Setting
♦
1 Fan Setting
♦
Adjustable thermostat
♦
Oscillation Function
Turning the Unit On or Off
NOTE: Refer to the control panel and remote control
illustrations at the start of this manual for a full list of
the indicators and buttons mentioned in the sections
below.
♦
To turn the unit On or Off, plug it into a mains
socket and press the On/Off button on the unit’s
control panel. Air will begin emitting from the front
grille and the LED display will show the currently
selected temperature to show the unit has been
powered up.
♦
Press the On/Off button again while the unit is in
operation to put it into Standby mode. The text ‘Of’
will appear on the unit’s LED display and air will
stop emitting from the front grille to show the unit
has been put into Standby mode.
♦
Press this button once more while the unit is in
Standby mode to resume operation.
NOTE: If the fan is put into Standby mode when
operating on a high heat level or directly after a heat
setting has been changed, air will continue emitting
from the front grille for approximately 45-60 seconds
as the motor cools down. The unit will automatically
revert to Fan mode and the LED strip around the unit
will turn blue to indicate this is the case. When the
motor is fully cooled down, the LED strip around the
unit will go out and air will stop emitting from the front
grille, as described above.
♦
To turn the unit off completely, unplug it from
the mains. The unit’s LED display will go out to
indicate it has been powered down.
Summary of Contents for BXSH37013GB
Page 11: ...ENGLISH Original instructions 11 ...
Page 12: ...11 2020 ...
