Black & Decker CD400A-XE, Manual

6

E N G L I S H

balance at all times.

 This enables better 

control of the power tool in unexpected 
situations.

f. Dress properly. Do not wear loose clothing 

or jewellery. Keep your hair, clothing and 
gloves away from moving parts.

 Loose 

clothes, jewellery or long hair can be caught in 
moving parts.

g. If devices are provided for the connection of 

dust extraction and collection facilities, 
ensure these are connected and properly 
used.

 Use of dust collection can reduce 

dust-related hazards.

4. Power tool use and care
a. Do not force the power tool. Use the correct 

power tool for your application.

 The correct 

power tool will do the job better and safer at the 
rate for which it was designed.

b. Do not use the power tool if the switch does 

not turn it on and off.

 Any power tool that 

cannot be controlled with the switch is 
dangerous and must be repaired.

c. Disconnect the plug from the power source 

and/or the battery pack from the power tool 
before making any adjustments, changing 
accessories, or storing power tools.

 Such 

preventive safety measures reduce the risk of 
starting the power tool accidentally.

d. Store idle power tools out of the reach of 

children and do not allow persons unfamiliar 
with the power tool or these instructions to 
operate the power tool.

 Power tools are 

dangerous in the hands of untrained users.

e. Maintain power tools. Check for 

misalignment or binding of moving parts, 
breakage of parts and any other condition 
that may affect the power tools operation. If 
damaged, have the power tool repaired 
before use.

 Many accidents are caused by 

poorly maintained power tools.

f. Keep cutting tools sharp and clean.

 Properly 

maintained cutting tools with sharp cutting 
edges are less likely to bind and are easier to 
control.

g. Use the power tool, accessories and tool bits 

etc. in accordance with these instructions, 
taking into account the working conditions 
and the work to be performed.

 Use of the 

power tool for operations different from those 
intended could result in a hazardous situation.

5. Service
a. Have your power tool serviced by a qualified 

repair person using only identical 
replacement parts.

 This will ensure that the 

safety of the power tool is maintained.

b. Power to the tool should always be supplied 

via residual current device with a rated 
residual current of 30mA or less.

Never use a light socket.

Using an extension cable

Always use an approved extension cable suitable
for the power input of this tool (see technical data).
When using a cable reel, always unwind the cable
completely.

CARTON CONTENTS

The carton contains:
1 Sander
1 Sanding sheet
1 Dust adaptor (CD400A-XE/KA196-XE/KA196E-XE)
1 Dustbag (KA273-XE)
1 Instruction manual
1 Parts diagram

Electrical safety

Additional safety instructions for sanders

This tool is double insulated; therefore no 

earth wire is required. Always check that the 

power supply corresponds to the voltage 

on the rating plate.

Always wear a dust mask whenever sanding.

Thoroughly remove all dust after sanding.

Take special care when sanding paint which is 

possibly lead based or when sanding some 

woods and metal which may produce toxic dust:
- Wear a dust mask specifically designed for  

   protectiona gainst lead paint dust and fumes 

   and ensure that persons within or entering the 

   work area are also protected.

- Do not let children or pregnant women enter 

   the work area.

- Do not eat, drink or smoke in the work area.

- Dispose of dust particles and any other debris 

   safely.