CHARGING PROCEDURE- FIGURES I, J, K
The battery can be removed from the tiller for charging
or left in place. To remove the battery refer to
figure H
.
CHARGING WITH BATTERY IN PLACE IN TILLER
1. Remove
safety key I-1
.
2. Align the
charger plug I-2
with the
arrow I-4
on top and
insert the charger plug into the
receptacle I-3
on the
tiller
(green terminal to green terminal, white terminal
to white terminal).
CHARGING WITH BATTERY REMOVED FROM TILLER
1. Remove
safety key I-1
.
2. With the battery removed, insert the
charger plug J-1
(with the arrow on top) into the
receptacle J-2
on the
battery. The charger connector can only be plugged into
the tiller receptacle or battery one way.
3. Insert the
120 volt plug K-1
of the
charger K-2
into the
wall receptacle.
4. The
red LED K-3
on the charger should come on
indicating you have power and the battery is being
charged. Check the charger for the red LED, if it is not
on check the charger connector for proper alignment
(step 2). The red LED should extinguish and the
green
LED
will come on when charging is complete (takes
approximately 20 hours to charge a fully discharged
battery).
5. It is recommended to leave the battery on constant
charge (between tiller uses) for optimum performance
during the tilling season.
9
I
J
K
