ENGLISH
Power
tools are dangerous in the hands of untrained users.
Many accidents are caused by poorly
maintained power tools.
Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
This
will ensure that the safety of the power tool is maintained.
@
Additional safety warnings for sanders
Holding the
work by hand or against your body leaves it unstable and
may lead to loss of control.
@
Contact with or inhalation of dusts
arising from sanding applications may endanger
the health of the operator and possible bystand-
protection against dust and fumes and ensure
that persons within or entering the work area are
also protected.
Thoroughly remove all dust after sanding.
Take special care when sanding paint which is possibly
lead based or when sanding some woods and metal which
may produce toxic dust:
Do not let children or pregnant women enter the work
area.
Do not eat, drink or smoke in the work area.
Dispose of dust particles and any other debris safely.
The intended use is described in this instruction manual.
The use of any accessory or attachment or performance
of any operation with this tool other than those recom-
mended in this instruction manual may present a risk of
personal injury and/or damage to property.
This appliance is not intended for use by persons (includ-
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they do not
play with the appliance.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
b. Power to the tool should always be supplied via residual
current device with a rated residual current of 30mA or
less.
Summary of Contents for DUOSAND KA330E-XE
Page 1: ...KA330E XE ww w blackanddecker com au Australia New Zealand ...
Page 2: ...2 C E B A D F ...
Page 3: ...3 H G ...
