10
DIRECT CODE ENTRY
1. Press and quickly release the desired
mode button (TV, VCR, etc.).
2. Press and hold the SETUP button until
the Mode button stays on. You can
now release the SETUP button
3. Enter the 3 digit code from the code
table (on separate sheet).
4. With your device on, press CHANNEL
UP. If the device responds, no further
programming is required. Note: If there
is no response OR if some buttons do
not operate your equipment, try one of
the other codes for your brand. If it still
does not work go to page 8
1.
2.
3.
PROGRAMMING WITH CODE
SEARCH
If your product does not respond after
you have tried all the codes for your
brand, or if your brand is not listed, try
searching for your code by following
these steps.
1. Turn on the device (TV, VCR, etc.) to
be controlled.
2. Press and quickly release the desired
mode button (TV, VCR, etc.).
3. Press and hold the SETUP button until
the Mode button stays on. You can
now release the SETUP button.
4. Press the CHANNEL UP button
repeatedly (up to 300 times) until the
device to be controlled changes
channel. The green indicator blinks off
with each button press. If you
accidentally overshoot the code
required, press the CHANNEL DOWN
button to backtrack through the library
until the device changes channel.
Pressing CHANNEL UP changes
direction to forward again.
5. Press and release MUTE to install the
code.
Most users will store VCR codes under
the VCR button, DVD codes under DVD,
etc. If (for example) you want to store a
VCR code under DVD, first follow the
procedure for Direct Code Entry and
press DVD in step 1 of Direct Code
Entry, then enter ANY VCR code in step
3 of Direct Code Entry. Then follow the
steps above for Code Search (or Brand
Search, page 11).
NOTE: If the device does not have a
CHANNEL UP button, use PLAY (VCR
only) or POWER instead. Code Search
starts from the currently stored three digit
number under that mode.
2.
3.
5.
4.
CODE ENTRY
Write your codes down here for easy
reference later.
TYPE
TYPE STORED
CODE
VCR
DVD
TV
CABLE
SAT
TV
622715-00 Master Remote manual 2/4/04 9:17 AM Page 10
