9
CODE SETUP
The SETUP button is used to setup the
remote to operate your TV, VCR, etc. You
can either setup the remote using the
code for your brand of product, from the
code tables (on separate sheet), or you
can search through the library of codes
until you find a code that works for your
product.
Please refer to “Programming with Code
Search” on page 10 for more information
on using the code search feature to learn
how to search through the library of
codes for your products.
NOTE: You can store any kind of code
under any mode (except TV). i.e. you
can store a VCR code under the DVD
button, or a DVD code under the
CBL/SAT button, etc. However, you can
only store TV codes under the TV button.
SETUP
To operate buttons
below this line you
must synchronize
the remote into a
Freewire Messenger
Hub. See page 12.
SETUP, cont.
TV/VCR/INPUT
When in TV mode the TV/VCR/INPUT
button performs the INPUT source switch
function.
When in a mode that has been
programmed for VCR the
TV/VCR/INPUT button performs the
TV/VCR antenna switch function.
When in a mode that has been
programmed for Cable the
TV/VCR/INPUT button performs the A.B
switch function.
When in a mode that has been
programmed for SAT the
TV/VCR/INPUT button performs the
TV/SAT switch function.
When in a mode that has been
programmed for DVD the
TV/VCR/INPUT button performs the DVD
Setup function.
TV/VCR AND TV/DVD COMBO
UNITS
Note that for some TV/VCR and TV/DVD
combo units you might need to set up
two different buttons to control both parts
of the combo unit. E.G., (referring to the
Direct Code Entry section on the
following page) you might need to set up
a code under the TV button to
control the TV part of the combo unit
AND a separate code for the
VCR or DVD under any other button you
choose.
ADVANCED FUNCTIONS
622715-00 Master Remote manual 2/4/04 9:17 AM Page 9
