Black & Decker FSM1630-XE, Original Instructions Manual

8

ENGLISH

(Original instructions)

Note:

head to the steam head.



delta head clicks into place.

Caution! Always place the steam mop on the resting mat (8) 

with the handle (4) in the upright position when stationary and 

make sure the steam mop is turned off when not in use.

Filling the water tank (Fig.  H)

The watertank on your steam mop is removable for convi-

This Steam Mop incorporates an anti-calc system to help 

prolong the life of the system.

Note: Fill the water tank with clean tap water.

Note: In areas of very hard water, the use of de-ionised water 

is recommended.



  Remove the water tank (3).



(20).



  Fill the water tank (3) with water. 

Warning! Your water tank has a 0.5 litre capacity. Do not over 





Note:

Use

Important! This unit will kill 99.9% of bacteria & germs when 

Switching on and off



  To switch the appliance on, press the ON/OFF button (1). 

It takes approximately 15 seconds for the steam mop to 

heat up.

Note:

-

ervoir will glow red. Once the steam mop is ready to use the 

water reservoir will glow blue.



  To switch the appliance off, press the ON/OFF button (1).

Caution! Never leave the steam mop in one spot on any 

surface for any period of time. Always place the steam mop on 

the resting mat (8) with the handle (4) in the upright position 

when stationary and make sure the steam mop is turned off 

when not in use.

Caution! Always empty the steam mop after use.

Smartselect

TM

 Technology (Fig. J)

TM

 button (2) 

which shows various cleaning applications. They are used to 

select the correct operating mode for your particular cleaning 

operation.

Using Smartselect

TM

 , choose from one of the following applic-

ations by pressing the smartselect button (2) until the required 

setting is selected: 

Wood/Laminate

Stone/Marble

Tiles/Vinyl

The steam mop will select the correct volume of steam 

required for your particular cleaning operation.

Note: Always check you are using the correct setting before 

using your steam mop. For convienience the steam mop will 

remember the last setting you chose.

Steam burst (Fig. I)

The steam mop is equipped with a steam bust button to aid in 

the removal of stubborn marks and stains.



  During use, press the steam bust button (21) to apply 

extra cleaning power.

Note: The stem burst will last for 10 seconds then the stem 

mop will return to the chosen setting.

Hints for optimum use

General

Caution!

cleaning pad.



  During use you can use the cable mamagement clip (11) 

to keep your cable out  of the way of the work area..



mop.



  The easiest way to use the machine is to tilt the handle to 

a 45˚ angle and clean slowl

y, covering a small area at a 

time.



  Do not use chemical cleaners with your steam mop. To 

can use the steam burst button to apply extra steam to 

the area or pre-treat with a mild detergent and some water 

before using the steam mop.

Smartselect