English
3
SAVE THESE
INSTRUCTIONS
SYMBOLS
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ..............................volts
A ..............................amperes
Hz............................hertz
W.............................watts
min .........................minutes
or AC .............alternating current
or DC
....direct current
no ...........................no load speed
...........................Class I Construction
(grounded)
...........................earthing terminal
..........................safety alert symbol
...........................Class II Construction
(double insulated)
.../min or rpm...revolutions or reciprocation
per minute
Wh ..........................Watt Hours
ASSEMBLY
WARNING:
Do not attempt to modify or
repair the appliance
Wall Mounting
• The product can be wall mounted, if desired, using the
wall mount bracket, screws and anchors supplied. To wall
mount the vac, refer to
Figures
B, C, D and E
.
•
Figure B
- Mark the location of the screw holes (within
reach of an electrical outlet for chargeing the vac while it
is on the wall bracket).
•
Figure C
- Insert the charger cord into the curved slot in
the wall mount bracket
8
leaving approximately 8–9
inches (203mm - 227mm) excess as shown.
Fig. B
Fig. C
8
8
•
Figure D
- Hang the vac on the wall by placing the
opening on the base of the vac over the hooks in the
wall mount bracket as shown in
Figure
C.
Fig. D
•
Figure E
- Insert the jack plug
10
nto the charging socket.
10
Fig. E
Charging the battery
WARNING:
For use only with the supplied
charger.
From new, the rechargeable cells of the product need a
minimum charge time of 16 hours to ensure full power.
• The switch must be in the off (“O”) position, the product
will not charge if it is in any other position.
•
Figure
F
- Plug the jack plug
10
of the charger into the
charging socket
3
of the tool. Plug the charger into any
standard 120 Volt 60 Hz electrical outlet.
Fig. F
10
• While charging, the charger may get warm, this
is perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely. The
charger automatically reduces power consumption
when charging is complete.
WARNING:
Do not charge the battery
at ambient temperatures below 39°F (4°C) or above
104°F (40°C).
