Black & Decker HVLP400, Instruction Manual

Safety of others

u

  This appliance is not intended for use by persons (includ-

ing children) with reduced physical, sensory or mental 

capabilities, or lack of experience and knowledge, unless 

they have been given supervision or instruction concern-

ing the use of the appliance by a person responsible for 

their safety.

u

  Children should be supervised to ensure that they do not 

play with the appliance.

8

ENGLISH

(Original instructions)

Residual risks.

Additional residual risks may arise when using the tool which 

may not be included in the enclosed safety warnings. These 

risks can arise from misuse, prolonged use etc.

Even with the application of the relevant safety regulations 

and the implementation of safety devices, certain residual 

risks can not be avoided. These include:

u

  Injuries caused by touching any moving parts.

u

  Injuries caused by touching any hot parts.

u

  Injuries caused when changing any parts or accessories.

u

  Injuries caused by prolonged use of the appliance. When 

using any appliance for prolonged periods ensure you 

take regular breaks.

Labels on the appliance

The following pictograms are shown on the tool:

:

Warning! To reduce the risk of injury, the user 

must read the instruction manual.

R

Warning! Do not expose the appliance to rain or 

high humidity.

Warning! Keep bystanders away.

O

Warning! Wear safety glasses or goggles when 

operating this tool.

6

Warning! Wear a respirator or mask.

&

Warning! 

Electrical safety

#

This tool is double insulated; therefore no earth 

wire is required. Always check that the power 

supply corresponds to the voltage on the rating 

plate.

u

  If the supply cord is damaged, it must be replaced by the 

manufacturer or an authorised Black & Decker Service 

Centre in order to avoid a hazard.

u

  When using the tool outdoors, only use extension cables 

intended for outdoor use. A suitable rated Black & Decker 

extension cable of up to 30 m can be used without loss of  

power.

u

  Electric safety can be further improved by using a high-

sensitivity 30 mA residual current device (RCD).

Features

This appliance includes some or all of the following features.

  1. On/Off switch

  2. Spray trigger

  3. Sprayer

  4. Power unit

  5. Air hose

  6. 

  7. Lid

  8. Flow control knob

  9. Flow indicator

 10. Pattern select nozzle

 11. Filter cover

 12. Mixing bucket

14. Metal canister

13. Viscosity cup

Assembly

Warning! Before assembly, make sure that the tool is 

switched off and unplugged.

round.

u

with the lid (7) to the left.

u

u

  Tighten the locking ring (16) by turning it clockwise.

The liquid being sprayed may need to be thinned (diluted) 

before staring. When thinning, use the proper liquid thinner 

recommended on the container by the material manufacturer.

Warning!

55°C.

Note : A mixing bucket (12) is provided to use when transfer-

ring spray material from the original container into the bucket 

Note : A viscosity cup (13) is provided to determine the 

“runout time” of the material being used.