6
7
negative (black) clamp to vehicle chassis or
engine block away from battery. Do not connect
clip to carburetor, fuel lines, or sheet-metal body
parts. Connect to heavy gauge metal part of the
frame or engine block.
6. For positive-grounded vehicle, connect negative
(black) clamp from battery charger to negative
(NEG, N, –) ungrounded post of battery. Connect
positive (red) clamp to vehicle chassis or engine
block away from battery. Do-not connect clip to
carburetor, fuel lines or sheet-metal body parts.
Connect to a heavy gauge metal part of the frame
or engine block.
Important! If the connections to the battery’s
positive and negative terminals are incorrect,
the Reverse Polarity Indicator will light and the
unit will sound a continuous alarm until the
clamps are disconnected. Disconnect clamps and
reconnect to battery with correct polarity.
7. Turn the jump-starter power switch to the on
position.
8. Start the vehicle and crank the engine in 3 to 6
second bursts.
Important! If the engine doesn’t start within 6
seconds let the units internal battery cool for 3
minutes before making another attempt.
9. When the vehicle starts, turn the jump-starter off/
on switch to the off position.
10. Leave the vehicle’s engine running.
11. Disconnect the (–) black clamp connected to the
engine or chassis first, followed by the (+) red
clamp that is connected to the battery positive (+)
terminal.
12. Carefully press the negative (black) jumper cable
wire into the storage channel starting at the end
furthest from the clamp.
13. Clamp the negative (black) clamp onto the clamp
holder.
14. Carefully press the positive (red) jumper cable
wire into the storage channel starting at the end
furthest from the clamp.
15. Clamp the positive (red) clamp onto the clamp
holder.
16. Charge the unit as soon as possible.
17. Make sure that the jump-starter power switch
is turned off while the unit is being charged or
stored.
Using the 12V dc socket
This portable power source can be used with all 12V
dc accessories equipped with a male accessory socket
plug that are rated up to 5 amps.
1. Lift up the cover of the unit’s 12V dc socket.
2. Insert the 12 volt dc plug from the device into
the 12V dc accessory socket on the unit. DO NOT
EXCEED A 5 AMP LOAD.
3. Switch on the device and operate as usual.
4. Periodically press the battery power level button
to check battery status.
Using the USB port
1. Push the USB power button to turn the USB port
on. The USB power indicator will light.
2. Lift up the cover of the USB port.
3. Plug the USB-powered device into the USB port
and operate normally.
4. Periodically press the battery power level button
to check battery status.
Notes:
This unit’s USB port does not support data communication.
It only provides 5 volts/2A dc power to an external USB-
powered device.
Make sure the USB power button is in the off position when
the unit is being recharged or stored.
Some household USB-powered electronics will not operate
with this unit.
TROUBLESHOOTING
Problem
Solution
Unit will not
charge
• Make sure the power switch is in
the off position.
• Make sure the jack of the mains
charging adapter is properly
connected to both the unit and a
functioning mains power socket.
Unit fails to
jump-start
• Make sure unit’s power switch is
in the on position.
• Check that jump-starter has
a full charge. Recharge unit if
necessary.
• Make sure a proper polarity cable
connection has been established.
12V dc
accessory
outlet will
not power
appliance
• Make sure the the appliance does
not draw more than 5 amps.
• Check that unit has a full charge.
Recharge unit if necessary.
USB port will
not power
appliance
• Make sure the USB charging
port power button is in the on
position.
• Make sure the the appliance does
not draw more than 2 amps.
• Check that unit has a full charge.
Recharge unit if necessary.
If the unit does not charge or operate after following
the above directions, contact the manufacturer.
MAINTENANCE
This unit has been designed to operate over a long
period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance or
cleaning of the unit, unplug it from the power supply.
• From time to time wipe the unit with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do
not immerse the unit in water.
• Clean the outside case of the jump starter with a soft
cloth and, if necessary, mild soap solution.
• Do not allow liquid to enter the unit’. Do not operate
when the battery charger is wet.
• Keep the cords loosely coiled during storage to
prevent damage to the cords.
PROTECTING THE ENVIRONMENT
Correct disposal of this product
This marking indicates that this product
should not be disposed with other
household waste throughout the EU. To
prevent possible harm to the environment
or human health from uncontrolled
waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return
your used device, please use the return and collection
systems or contact the retailer where the product
was purchased. They can take this product for
environmentally safe recycling.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at municipal
waste sites or by the retailer when you purchase a
new product.
Lead acid batteries can be recharged many times. At
the end of their useful life, discard batteries with due
care for our environment:
• Do not dispose of the battery in fire, as this may
result in an explosion.
• Lead acid (Pb) batteries are recyclable. They
must not be disposed of with household waste.
The battery must be removed and disposed of in
accordance with local regulations.
• Do not short-circuit the battery terminals.
• Be aware that the battery is heavy.
• If possible, operate the appliance to run the battery
down completely.
• Place the battery in a suitable packaging to ensure
that the terminals cannot be short-circuited.
SPECIFICATIONS
Boost Ampere:
12V dc, 300A
instantaneous
Battery Type:
Maintenance-free, sealed
lead acid, 12V dc, 7Ah
dc accessory socket:
12V dc, 5A
USB port:
5V dc, 2A
Mains charging adapter
Input:
100-240V ac, 50/60Hz
Output:
14,5V dc, 750mA
WARRANTY
Our goods come with guarantees that cannot be
excluded under the Australian & New Zealand
Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation
for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of
acceptable quality and the failure does not
amount to a major failure.
Baccus Worldwide LLC is confident of the quality of
its products and offers an outstanding warranty. This
warranty statement is in addition to and in no way
prejudices your statutory rights under the Australian &
New Zealand Consumer Law.
If a Baccus Worldwide LLC product becomes
defective due to faulty materials, workmanship or
lack of conformity, within 24 months from the date
of purchase, Baccus Worldwide LLC guarantees to
replace defective parts, repair products subjected to
fair wear and tear or replace such products to make
sure of the minimum inconvenience to the customer
unless:
• The product has been used for trade, professional or
hire purposes;
• The product has been subjected to misuse or
neglect;
• The product has sustained damage through foreign
objects, substances or accidents;
• Repairs have been attempted by persons other than
Baccus Worldwide LLC service staff.
To claim on this warranty, you will need to submit
proof of purchase and return the allegedly defective
product to Baccus Worldwide LLC’s local market
distributor, at your expense.
Please visit our website www.baccusworldwide.com
to register your new Baccus Worldwide LLC product
and to be kept up to date on new products and special
offers. Further information on the Baccus Worldwide
LLC brand and our range of products is available at
www.baccusworldwide.com.
J312BAU_Manual_091216.indd 6-7
9/12/2016 11:59:48 AM
