Black & Decker JIS300, Original Instructions Manual

Warning!

 Always check the rotary 

sieve before use. If you detect any 
cracks or damage, do not use the 

appliance and contact the nearest service 
centre or take the appliance to your dealer.

5.  Fit the lid (B) by lowering it into position. 

Press down firmly until it locks into 
place. (the lid can only be removed by 
sliding the release button (G) to the 
unlock position)

6.  Fit the juice jug (I). Push firmly until it 

clicks into place.

7.  Fit the ice shaving (J) by lowering it into 

position.

8.  Fit the ice shaver lid (K) and lock it into 

position by turning it anti-clockwise.

Use

Juicing

1.  Fully assemble the appliance (including 

the ice shaver) the appliance will not run 
unless both lids are securely locked in 
position.

2.  Place the appliance on a flat, stable 

surface and connect it to the electrical 
supply.

3.  Select the juicing function by turning the 

control knob (F) anti-clockwise.

4.  Remove the pusher (A) and add the 

ingredients, using the pusher to guide 
the ingredients onto the blades.

  - While you are preparing juice, you can 

empty the pulp container by switching 
the appliance off and carefully removing 
the pulp container. Note: Reassemble the 
empty pulp container before you 
continue juicing.

5.  When juicing is completed, return the 

control knob (F) to the O (off) position.

The appliance should be disconnected from 
the mains supply before removing the jug.

The Juicer should not be run for longer than 
2 Minutes. After each 2 Minutes use, the 
Juicer should be allowed to cool for at least 
2 minutes.

The appliance has a safety feature which 
prevents overheating. If the device gets too 
hot it will automatically shut off. The 
appliance should be left for 15 minutes to 
fully cool before re-starting.

Ice shaving

1.  Fully assemble the appliance the 

appliance will not run unless both lids are 
securely locked in position.

2.  Place the appliance on a flat, stable 

surface and connect it to the electrical 
supply.

3.  Put ice into the ice shaver (J) and fit the 

ice shaver lid (K) securely.

4.  Select the Ice shaver function by turning 

the control knob (F) clockwise.

5.  When ice shaving is completed, return 

the control knob (F) to the O (off) 
position.

The appliance should be disconnected from 
the mains supply before removing the jug.

The appliance should not be run for longer 
than 2 Minutes. After each 2 Minutes use, 
the appliance should be allowed to cool for 
at least 1 minute.

5

ENGLISH