ENGLISH • 29
Caution! Risk of bursting:
f
This product can inflate up to 100 pounds per square
inch of pressure (psi). In order to avoid an excess
in inflation, carefully follow the instructions of the
items to inflate. Never exceed the recommended
pressures. Bursting items may cause serious injuries.
f
Always control the pressure with the pressure gauge.
f
Never leave the inflator unattended during use.
Caution! Risk of property damage
Do not operate inflator continuously for extended periods
of time (approximately 10 minutes, depending on
ambient temperatures), as it may overheat. In such event,
inflator will automatically shut down. Immediately turn
OFF the Inflator Power Switch. Restart after a cooling
down period of approximately 10 minutes.
Inflating tires or products with valve stems
1. Place connector (chuck) on valve stem.
2. Ensure connector is pushed on to valve stem as far
as possible before closing thumb latch.
3. Make sure latch is secure.
4. Turn ON the Inflator Power Switch.
5. Check pressure with the pressure gauge.
6. When desired pressure is reached, open thumb latch
and remove connector from valve stem.
7. Turn OFF Inflator Power Switch.
8. Allow unit to cool before storing away.
9. Store inflator hose and tire fitting in storage compartment.
10. Recharge the unit before storing away.
Inflating other inflatables without valve stems
Inflation of other items requires use of one of the adapters
(nozzles).
1. Select the appropriate nozzle, located on the inside
back cover.
2. Insert appropriate adapter (i.e. needle) into connector
(chuck) and close thumb latch.
3. Small items such as volleyballs, footballs, etc. inflate
very rapidly.
4. Insert adapter (i.e., needle) into item to inflate to
appropriate pressure.
5. Turn ON the Inflator Power Switch — inflate to desired
pressure or fullness.
6. Remove adapter.
7. Switch the Inflator Power Switch OFF.
8. Recharge the unit before storing away.
MAINTENANCE
Your Black & Decker corded/cordless appliance/tool
has been designed to operate over a long period of time
with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular
cleaning.
This product has a sealed lead acid battery that should be
kept fully charged. Recharge before first use, immediately
after each use, and every 90 days if not used. Failure to do
this may reduce the battery life dramatically.
Warning! The use of any accessory not recommended
for use with this tool could be hazardous.
Warning! Before performing any maintenance on
corded/cordless power tools:
f
Switch off and unplug the appliance/tool.
f
Or switch off and remove the battery from
the appliance/tool if the appliance/tool has a separate
battery pack.
f
Or run the battery down completely if it is integral
and then switch off.
f
Unplug the charger before cleaning it. Your charger
does not require any maintenance apart from regular
cleaning.
Regularly clean the ventilation slots in you appliance/tool/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
from the interior (when fitted).
ACCESSORIES
The performance of your tool depends on the accessory
used. Black & Decker and Piranha accessories are
engineered to high quality standards and designed to
enhance the performance of your tool. By using these
accessories you will get the very best from your tool.
when you purchase a new product.
At the end of their useful life, discard batteries
with due care for our environment.
Do not short-circuit the battery terminals.
f
Do not dispose of the battery(s) in a fire as this may
result in a risk of personal injury or an Explosion.
f
Run the battery down completely, then remove it
from the tool.
Batteries are recyclable. Place the battery(s) in a suitable
packaging to ensure that the terminals cannot be hortcircuited.
Take them to any authorised repair agent or a local
recycling station.
