Black & Decker KA160-XE, Original Instructions Manual

8

Labels on tool

The following pictograms are shown on the tool:

:

Warning!

 To reduce the risk of injury, user must 

read the instruction manual.

Electrical safety

#

This tool is double insulated; therefore no earth wire 

is required. Always check that the power supply 

corresponds to the voltage on the rating plate.

u

If the supply cord is damaged, it must be replaced by the 

manufacturer or an authorised Black & Decker Service 

Centre in order to avoid a hazard.

Features

This tool includes some or all of the following features.

  1. On/off switch

2. Dust extraction connector

3. Base

4. Tip holder

5. Sanding base tip

6. Finger attachment

  7. 

8. Screw

  9. 

In addition, this tool is supplied with some or all of the 

following accessories:

Accessory

Recommended application 

and use

u

Coarse grit sandpaper Fast paint, varnish and rust 

removal

u

Medium grit sandpaper Paint, varnish and rust removal

u

  Fine grit sandpaper 

u

  Sanding between coats

u

Detail sanding tips

Corners and hard to reach places

u

  1 OT polishing/stripping   Polishing metals, stripping 

wool

varnish and glass cleaning

u

Grey foam pad

Applying and removing polish

u

Red non-woven pad

Heavy scrubbing and rust 

removal

u

Grey abrasive paper

Polishing plastics

u

  Contour attachments 

Assembly

Warning!

 Before assembly, make sure that the tool is 

switched off and unplugged.

u

Detach the two diamond-shaped tips (10) from the 

sanding sheet (11).

u

Hold the tool with the sanding base facing upwards.

u

Place the sanding sheet (11) onto the sanding base, 

making sure that the holes in the sheet line up with the 

holes in the base.

The diamond-shaped tip (10) can be reversed and replaced 

when worn.

u

When the front part of the tip is worn, detach it from the 

sheet, reverse it and press it onto the sanding base again.

u

When the whole tip is worn, remove it from the sanding 

u

way as the sanding sheets.

When the sanding base tip (5) or tip holder (4) is worn, it can 

be reversed or replaced. Spare parts are available from your 

Black & Decker dealer.

u

Remove the screw (8).

u

Reverse or replace the worn part.

u

Fit and tighten the screw.

u

Remove the screw (8).

u

Remove the diamond-shaped tip holder (4) from the 

sanding base.

u

u

Fit and tighten the screw.

u

attachment.

u

Remove the screw (8).

u

Remove the diamond-shaped tip holder (4) from the 

sanding base.

u

u

Fit and tighten the screw.

u

u

u

place.

u