5
ENGLISH
Additional Safety Warnings
• Do not use this appliance with a
programmer, timer or any other device that
switches the heater on automatically, since a
fire risk exists if the heater is covered or
positioned incorrectly.
• Do not use this appliance in the immediate
surroundings of a bath, a shower or a
swimming pool.
• Use this appliance on a level surface, away
from steps of stairs.
• Combustible materials such as furniture,
pillows, bedding, papers, clothes and
curtains must be kept at least 1m from the
appliance. Keep loose clothing & long hair
away from vents.
• Do not allow anything to block the vents of
the appliance. A gap of at least 50cm is
advised.
• Always use and store in a dry area.
• Do not use in areas where gas, paint or
other flammable goods may be present.
• This heater is filled with a precise quantity of
special oil. Repairs requiring opening of the
oil container are only to be made by the
manufacturer or his service agent who
should be contacted if there is an oil leak.
• When disposing the heater, follow the local
regulations concerning the disposal of oil.
• Never pull the unit by the cord. Always use
the handle provided when moving the
appliance.
• Always disconnect the appliance from the
socket outlet before moving it to a new
location.
• Keep the cord set away from hot parts of the
appliance.
• This appliance must be earthed.
• This appliance is fitted with a safety device
which will prevent the heater working unless
it is in its normal, upright working position.
Note
• In case of overheating, a cut-out will operate
and the appliance will stop working. If the
appliance stops operating, return all heating
buttons to the off (0) position, unplug the
appliance and allow it to cool for at least 10
minutes before attempting to use it again.
• In extreme conditions, a back-up cut-out will
operate. This will not re-set & the appliance
will need to be repaired by a qualified person.
Assembly
• Fit the wheels before using the appliance.
Never use the appliance without the wheels
fitted.
• Place the heater on the floor upside down. It
is quite normal to hear the oil moving inside
the radiator.
• Fit the bent end of the first wheel clamp (11)
into the hole in the wheel support (10).
• Place the support between the last 2 heating
fins (13).
• Swing the clamp around the radiator & insert
the free end into the hole in the support (10).
• Fit the wing nut (12) onto the clamp & rotate
it in a clockwise direction until tight.
• Repeat this procedure to fit the other wheels
at the opposite end of the appliance.
• Put the heater into its normal upright position.
Summary of Contents for OR11FD
