Fan Heater Operation:
• Fully unwind the cord & place the unit on a flat, even floor away from any obstructions and pointing towards
the area of the room to be heated.
• Press the fan heater button (8). Warm air will be blown into the room from the vents (9).
• To stop the fan heater, return the button (8) to the off (0) position.
Note:
This appliance must be attended in use.
Warning:
In order to avoid overheating, do not cover this appliance.
Safety Fuse:
• In case of overheating, a cut-out will operate and the appliance will stop working. If the appliance stops
operating, return all heating buttons to the off (0) position, unplug the appliance and allow it to cool for at
least 10 minutes before attempting to use it again.
• In extreme conditions, a back-up cut-out will operate. This will not re-set & the appliance will need to be
repaired by a qualified person.
How to take care of your Radiator
Cleaning your Radiator
• Switch off the appliance before cleaning, changing accessories or approaching parts which move in use.
• Do not immerse the appliance, cord set or plug in liquids
• Wipe the appliance with a damp cloth & dry thoroughly before using.
• Never use detergents or abrasives to clean this appliance.
Storing your Radiator
• When the appliance is to be stored, return the heating buttons to the off (0) position and unplug it from the
mains supply.
• Wrap the cord around the cord storage (6) and fasten the loose end of the cord in the cord clip (7).
Additional Safety Warnings:
• Do not use this appliance with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
• Do not use this appliance in the immediate surroundings of a bath, a shower or a swimming pool.
• Use this appliance on a level surface, away from steps of stairs.
• Combustible materials such as furniture, pillows, bedding, papers, clothes and curtains must be kept at
least 1m from the appliance. Keep loose clothing & long hair away from vents.
• Do not allow anything to block the vents of the appliance. A gap of at least 50cm is advised.
• Always use and store in a dry area.
• Do not use in areas where gas, paint or other flammable goods may be present.
• This heater is filled with a precise quantity of special oil. Repairs requiring opening of the oil container are
only to be made by the manufacturer or his service agent who should be contacted if there is an oil leak.
• When scrapping the heater, follow the local regulations concerning the disposal of oil.
• Never pull the unit by the cord. Always use the handle provided when moving the appliance.
• Always disconnect the appliance from the socket outlet before moving it to a new location.
• Keep the cord set away from hot parts of the appliance.
• This appliance must be earthed.
• This appliance is fitted with a safety device which will prevent the heater working unless it is in its normal,
upright working position.
-5-