7
BREW LATER FUNCTION
If BREW LATER function has not been previously set:
1. After the digital clock is set, press the BREW LATER button.
2. The LED light in the display next to BREW LATER illuminates and
flashes once per second.
3. Clock shows last BREW LATER time programmed (if no time has been
programmed, or unit has been unplugged, BREW LATER time defaults
to 12:00 a.m.).
4. Use HOUR and MIN buttons to set BREW LATER time (while BREW
LATER in display is blinking).
5. Press the BREW LATER button again to set the BREW LATER time.
Or, the coffeemaker will automatically set itself after 4 seconds with no
button pressed.
6. The unit will begin brewing at the BREW LATER time.
If BREW LATER function is already set:
1. Press BREW LATER button to check the BREW LATER time. The
clock will flash once per second and display the BREW LATER time
for 4 seconds. At this point, you may reset the BREW LATER setting if
desired.
2. To cancel the BREW LATER function; press and hold the “BREW
LATER” button for 3 seconds.
3. Four seconds after you stop pressing buttons, the clock reverts to
current time.
Note:
Even though BREW LATER is disabled, the BREW LATER time will
still be stored unless unit is unplugged.
CARE AND CLEANING
This product contains no user serviceable parts. Refer service to qualified
service personnel.
CLEANING
• Be sure the unit is unplugged and has cooled.
• Wash the removable parts in the top rack of the dishwasher or wash by
hand in hot water with dish detergent.
• Wipe the appliance’s exterior surface, control panel and carafe plate with
a soft damp cloth. Do not use abrasive cleansers or scouring pads. Never
immerse the coffeemaker in water.
• To clean the inside of the cover, open the cover and leave in the open
position. Wipe surfaces with a damp cloth.
CM1240B_29052_ES_IB_A.indd 7
CM1240B_29052_ES_IB_A.indd 7
4/20/22 4:49 PM
4/20/22 4:49 PM
