8
ENGLISH
Note:
When not in use the the accessories
(14&15) can be stored on the accessory
mounts (7).
Note:
When not in use the the floor head (9) can
be stored on the floor head mounts (25, fig E).
Use
Switching on and off (fig. E)
•
To switch the appliance on, press the on/off
switch (5).
•
To switch the appliance off, press the on/off
switch (5).
Vacuuming
•
When operating the appliance, make sure
that the hose is not trapped, twisted or
blocked.
Note:
When Vacuuming you should ensure that
the filter is fitted.
Note:
When Vacuuming on hard surfaces you
can extend the brushes on the floor head by
pressing down the brush release button
(26, fig D).
Optimising the suction force
In order to keep the suction force optimised, the
filters must be cleared regularly during use.
Emptying the dust bowl
(fig. F & G)
•
Lift the dust bowl release lever (16).
•
Lift the dustbowl (1) from the appliance.
•
Hold the dust bowl over a bin.
•
Press the dust cap release lever (17) and
empty the dust bowl.
•
Press the dust cap (18) back on until it clicks
into place.
•
Refit the dust bowl by placing the front end
into the appliance then pressing firmly on the
back end until it clicks into place.
Cord rewind (fig. H)
•
Press and hold the cord rewind button (8).
Storing the appliance
Warning!
When storing the appliance, switch
the appliance off and unplug it.
•
Store the appliance in a dry location. The
appliance can be carried by the handle (6).
Maintenance
Your Black & Decker corded appliance has been
designed to operate over a long period of time
with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool
care and regular cleaning.
Warning!
Before performing any maintenance
on corded appliances:
•
Switch off and unplug the appliance.
•
Regularly clean the ventilation slots in your
appliance using a soft brush or dry cloth.
•
Regularly clean the motor housing using a
damp cloth. Do not use any abrasive or
solvent-based cleaner.
Cleaning the filters (fig. I, J & K)
The Dustbowl may be cleaned with water by
running it under a tap all other components
should be cleaned with a soft dry brush or damp
cloth.
