6
ENGLISH
(Original instructions)
Use
24 hours.
Place the appliance on the charging base whenever it is
not in use. (WD9610 Only)
Warning! Before charging, be sure to empty all liquid contents
and dry thoroughly, to avoid damage to your appliance.
Charging the battery (Fig. E & F)
Make sure that the appliance is switched off. The battery
will not be charged with the on/off switch in the on posi-
tion.
Plug the jack plug of the charger (6) into the charging
socket (4) of the appliance (Fig. E). (WD4810 Only)
Place the appliance on the charging base (7) (Fig. F).
(WD9610 Only)
Plug in the charger. Switch on at the mains. The charging
indicator (3) will be lit.
Leave the appliance to charge for at least 16 hours.
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
indicator (3) will be lit as long as the appliance is connected to
the plugged-in charger.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C.
To switch the appliance on, slide the on/off switch (1)
forward to position 1.
To switch the appliance off, slide the on/off switch (1) back
to position 0.
Wet and dry pick up (WD4810 and WD9610 Only)
For everyday spills of dry material, use your appliance
without the squeegee accessory.
Warning! Your product is designed for light spills only.
This appliance can also be used to pick up everyday liquid
spills. Use the squeegee accessory on non-absorbent,
hard surfaces. On absorbent surfaces, such as carpet,
your appliance will pick up wet spills better without the
accessory.
For best performance on hard surface wet pickups, insert
squeegee into the bowl nozzle opening.
For best results when using this accessory, hold the appli-
ance at an angle of 45° and pull it slowly towards you.
there is any liquid in the bowl, do not turn the unit upside
down, sideways, point the nozzle upward, or shake the
vac excessively.
After picking up liquid substances clean the appliance and
not properly cleaned after wet pickups.
Before charging, be sure to empty all liquid contents and
dry thoroughly, to avoid damage to your appliance.
Optimising the suction force
cleared regularly during use.
Emptying and cleaning the product.
Warning!
regularly.
Press the release latch (2) and pull the dust bowl (5)
straight off.
While holding the dust bowl over a bin or sink, pull out the
To replace the dust bowl, place it back onto the handle
Warning!
-
WD9610)
Place the foam insert (10) into the centre of the wet/dry
Warning! Never use the appliance for wet applications without
water.
-
ever worn or damaged.
dealer.
