Chapter 4: Configuration
877-877-2269 | blackbox.com
Page 15
4.2.1 To change the status of a single power output port
1 Locate the required power output port entry by its ID number or Name (if given).
2 Click the corresponding State button to change the output port from ON to OFF, or vice versa.
4.2.2 To change the status of all power output ports
1 Locate the ALL ON and ALL OFF buttons below the Power Output section. As appropriate, click either the ALL ON or ALL OFF
button.
2 Click OK to confirm your choice in the subsequent popup.
Note: When the ALL ON button is pressed, the individual ports will be energized in a staggered sequence determined by the
Channel interval setting in the General configuration page.
4.2.3 To name a power output port
1 Locate the required power output port entry.
2 Click the corresponding Edit button. A cursor will appear within the Name field.
3 Enter the required name for the power output port and click the Update button.
Note: Name fields accept ASCII characters only. UTF-8 characters are not supported.