Page 9
EC24U3032
Chapter 3: Mounting Instructions
3. Mounting Instructions
3.1 Receiving, Unpacking, and Removing the Elite Wallmount Enclosure from the Pallet
Inspect for damage and report damage if there is damage before receiving. Refer to Section 2.3 for what‘s included
in the package.
Unpack the enclosure by carefully removing the corrugated carton and corners. Avoid damaging the enclosure when removing
packaging.
WARNING: Only trained service personnel should be used to remove the enclosure from the pallet. Also be sure you have a
sufficient number of service personnel. Do not attempt to move enclosures by yourself.
WARNING: Be careful when moving enclosures before installation. Sudden stops and starts, excessive force, obstructed routes,
and uneven floor surfaces may cause the enclosure to topple over.
3.2 Wood Studded Wall
Once the location on the wall has been determined, inspect the wall surface. The wall must be flat and square in the horizontal
and vertical plane to ensure the Elite Wallmount Cabinet closes correctly. If the wall is not flat and square, you might need to use
shims.
You can remove the rear section of the cabinet by removing the hinges. Mount the rear section to the wall using the
included hardware or install two horizontal bolts in studs (DO NOT TIGHTEN!) using a level. Hang the rear section on the two
bolts, install the lower two bolts (line up with a level) and tighten. Then tighten the upper two bolts.
WARNING: Improper handling and use of the Elite Wallmount Enclosure could result in equipment damage, serious injury,
or possible death.
Masonry Wall Surface
For a masonry wall surface, the installer must provide the appropriate hardware.
