9
CHAPTER 3: Installation
7. Connect one end of a UTP cable to each Balun’s RJ-45 modular jack, as
shown in Figure 3-1. These cables must carry at least three wire pairs, and
these wires must be pinned to RJ-45 Pins 1, 2, 3, 6, 7, and 8.
Figure 3-1. The Balun and its connectors.
8. Plug the other end of each UTP cable into the appropriate video wall outlet
or patch panel. When this is done, a complete cabling circuit should run
between the two baluns, as shown in Figure 3-2 below.
Figure 3-2. Two Baluns cabled together.
9. Reconnect and power up the video equipment.
Your RGB Video Balun system should be ready for continuous operation.
RED
VIDEO
PAIR 4
(7 & 8)
BLUE
VIDEO
PAIR 3
(1 & 2)
GREEN
VIDEO
PAIR 2
(3 & 6)
RGB Video Balun
RED
VIDEO
PAIR 4
(7 & 8)
BLUE
VIDEO
PAIR 3
(1 & 2)
GREEN
VIDEO
PAIR 2
(3 & 6)
RGB Video Balun
RED
VIDEO
PAIR 4
(7 & 8)
BLUE
VIDEO
PAIR 3
(1 & 2)
GREEN
VIDEO
PAIR 2
(3 & 6)
RGB Video Balun
RJ-45 for UTP
Category 3 or
higher UTP
