29
CHAPTER 3: Installation
3.5.2 G.703 LINE C
ONNECTION
The G.703 LINE connection provides an interface for the TX and RX signals
between the Converter and G.703 line equipment. To make this connection,
attach the wires from the line equipment to the terminal block on the
Converter this way:
NOTE
There is no + or - XMT or RCV. The unit is auto-detecting and non-
polarity sensitive.
• XMT (line equipment) to RCV (Converter);
• XMT (line equipment) to RCV (Converter);
• RCV (line equipment) to XMT (Converter);
• RCV (line equipment) to XMT (Converter);
• Optional: Ground (line equipment) to ground (Converter—the
rightmost terminal).
Figure 3-6. Wire-insertion details.
XMT
RCV
GND
1) Insert screwdriver into square hole.
2) Raise inserted screwdriver, putting pressure on
ramp inside square hole. Wire clamp in round hole
will open.
3) Insert stripped end of wire and remove screwdriver.
