24
REMOTE MINIBRIDGE
To connect a cable to either RMB, take these steps,
referring to Figure 3-1 below:
CAUTION!
Do not apply power to the Remote MiniBridge until you
finish this procedure. The RMB could be damaged and
you could suffer a dangerous electrical shock.
Figure 3-1. Attaching the cable to a 4-wire RMB.
1. Slip the included protective strain-relief boot over
the end of the wire, skinny end first, and slide it a
few inches up the wire.
Terminal
Block
Screw
Terminals
One Wire Pair
One Wire Pair
Shield (One End Only)
TX–
RX–
TX+
RX+
FGND