28
RACKMOUNT REMOTE POWER MANAGER USER’S MANUAL
2. On/off switching: The boot/seq. delay determines how long the power
manager will pause before proceeding to the next plug.
Examples
Assume that a user is only allowed access to plugs one through four, and that the
boot sequence delays for each plug have been set as follows: plug 1 = 1 second,
plug 2 = 2 seconds, plug 3 = 5 seconds, plug 4 = 1 minute.
If the user applies an On command to all four plugs, the power manager will
respond as follows:
1. Turn on plug 1, wait 1 second.
2. Turn on plug 2, wait 2 seconds.
3. Turn on plug 3, wait 5 seconds.
4. Turn on plug 4.
If a reboot command is applied to plug 3, the power manager will respond as
follows:
1. Turn off plug 3, wait 5 seconds, turn on plug 3.
If a reboot command is applied to all four plugs, the power manager will respond
as follows:
1. Turn off all four plugs (short delay between plugs).
2. Wait 1 second, turn on plug 1, wait 1 second.
3. Wait 2 seconds, turn on plug 2, wait 2 seconds.
4. Wait 5 seconds, turn on plug 3, wait 5 seconds.
5. Wait 1 minute, turn on plug 4.
4.3.3 S
ERIAL
P
ARAMETERS
M
ENUS
The Serial Parameters menus are used to configure the power manager’s serial
COM port and allow you to select parameters such as the baud rate, parity, and
modem initialization string. To access the Serial Parameters menu, proceed as
follows.
Summary of Contents for PS580A
Page 3: ......
