ALUMINUM DISTRIBUTION RACKS, RACEWAYS, AND ACCESSORIES
6
2. Aluminum Distribution Rack
Raceways
2.1 Available Models
The following models are available:
• Mill Aluminum Distribution Raceway for RM349A (part number RM378)
• Black Aluminum Distribution Raceway for RM330A-R3 and RM630A (part number RM044)
• Mill Aluminum Distribution Raceway for RM430A and RM631A (part number RM432)
2.2 What’s Included
Make sure you have the following parts before installing the Aluminum Distribution Rack Raceway.
• (1) Aluminum Distribution Rack Raceway
• (6)
1
⁄
2
-13" lockwashers
• (6)
1
⁄
2
-13 x 1" hex-head bolts
• (6)
1
⁄
2
" hexnuts
2.3 What You’ll Need to Supply
•
3
⁄
4
" socket or wrench
2.4 Installation Instructions
NOTE
This Rack Raceway attaches to each networking frame with 2 bolts, lockwashers, and
hexnuts. After you’ve properly installed the Rack, you’ll have 2 extra bolts,
lockwashers, and hexnuts left over.
A. Align the holes in the Aluminum Distribution Rack Raceway with the holes in the networking frames and
attach them with the hex-head bolts, lockwashers, and hexnuts and tighten. (See
Figure 2-1
on the next
page.)
B. Pull the knob on the cable gates to remove them from the Rack. Re-attach by pushing the knob in until it
locks.
