724-746-5500 | blackbox.com
Page 8
724-746-5500 | blackbox.com
SmartPath Enterprise Wireless Access Point, Outdoor Installation Guide
4.4 Flat Surface Mount
The following steps explain how to mount the LWN602WA on a flat surface. You will need the plane bracket and the four
sleeve-bolt assemblies.
1. Use the plane bracket as a template to mark the location of the mounting holes on the surface.
2. Drill a
5
⁄
16
” (8 mm) hole to a depth of 1.5" (38 mm) into each mark.
3. Remove the nuts and washers and hammer the unthreaded end of a sleeve-bolt assembly into each hole. Make sure the
slotted end of the sleeve goes into the wall. Be sure to leave a minimum of 3/8” (9.5 mm) of the threaded bolt protruding
from the front of the wall.
NOTE: If you are not installing the device on a concrete wall, you can use 2" (5 cm) threaded screws and plastic wall anchors (not
supplied) to mount the device.
Figure 8. Installing the base and plane bracket.
4. Place a lock washer and flat washer on each of the four hex screws and use the screws to attach the plane bracket to the back
of the LWN602WA, as shown in Figure 3.
5. Place the holes in the plane bracket over the mounting bolts and attach the unit using a hex nut, lock washer, and flat washer
on each bolt to tighten the unit to the surface. As you tighten the nuts, the flanges on the back of the bolt sleeve will expand
in the hole, securing the device in place.
Figure 9. Installing the hardware.
