15
CHAPTER 3: Installation
• For your safety, do not use this or any electrical product near water (unless
specifically designed for wet areas).
• Do not install wiring during thunder and lightning storms.
• Use caution when handling or installing any computer, telephone, video, or
electrical devices.
3.4 Installing the Modules
Separate installation manuals are included with each module. Each manual
contains the following general installation and removal instructions, along with
specific instructions for each individual module. Follow those instructions when
installing the modules into the SOHO Network Box.
To install a module into a SOHO Network Box:
1. Determine the area for installation.
2. Insert the metal tabs on the module at a 45-degree angle into the rail holes on
the module.
3. Swing the module inward and place the pushbutton into the hole on the
module.
4. Press the pushbutton to fasten the module to the SOHO Network Box.
NOTE
When installing an individual module in the SOHO Network Box, be sure
to place it above or below the interfacing module, when possible. This
will eliminate excessive cable crossing.
Removing a module from the SOHO Network Box:
1. Pull the pushbutton to release the module from the SOHO Network Box.
2. Swing the module outward.
3. Position the module at a 45-degree angle and pull to remove it from the
SOHO Network Box.
Summary of Contents for SOHO JPM1110A
Page 3: ......