13
CHAPTER 3: Installation
On the 4-Port Expansion Board (as shown above in Figure 3-2):
SWH -
for slave port 5
SWI -
for slave port 6
SWJ -
for slave port 7
SWK -
for slave port 8
Table 3-1 on page 9 lists the possible settings for the master port’s switch,
SWA. Table 3-2 on page 10 lists the possible settings for each slave port’s
switch. You can set the expansion-board switches before you actually insert the
board into the TEP; just be careful not to bump the switches when you insert
the board.
(text continues on page 16)
(BACK)
(FRONT)
INDIVIDUAL PORT SWITCHES
(PORTS 5 THRU 8)
PORT 8
PORT 7
PORT 6
PORT 5
SWK
OFF
SWJ
OFF
SWI
OFF
SWH
OFF
PORT 5
DTE
DCE
PORT 6
DTE
DCE
PORT 7
DTE
DCE
PORT 8
DTE
DCE
Fig. 3-2. The 4-Port Expansion Board.