STEP 8
Attach the (2) Side Panel Brackets to the Base
using (2) 8 x 20mm bolts, 8 mm washers, and 8
mm lock nuts. The circular tube at the top of the
Bracket should face the inside of the wagon.
STEP 9
Assemble the four Side Panels by inserting the
stakes on the Panels into the brackets on the
Base. When installing the Panels to the Base,
make sure that the stakes for attaching the
Panels to the Base are to the outside of the
wagon. Also, make sure that the notches for
the locking mechanisms are located in the
corners of the wagon.
STEP 10
Insert the (2) 100 mm pins through the holes in
the Side Panels and the Side Panel Brackets.
Once fully inserted, attach the Clips onto the
end of the Pins.
STEP 12
Attach the Front and Rear Panels to the Side
Panels by rotating the Lock Handles into
place. Once all Panels are locked together in
the upright position, tighten the 8mm lock
nuts on the Lock Handles for smooth
operation without being overly tight.
STEP 11
Assemble the Front and Rear
Panels by inserting the stakes on
the Panels into the brackets on the
Base and the (2) Fence Assembly
Pins. Make sure that the stakes for
attaching the Panels to the Base are
to the outside of the wagon. Also,
make sure that the Lock Handles in
the corners are located to the
outside of the wagon.
