IMPORTANT SAFETY INSTRUCTIONS
1.
READ ALL INSTRUCTIONS CAREFULLY BEFORE USE.
If you do not understand these instructions, need
clarification or further explanation, please call our toll free answer line for assistance at
1-800-304-1316
Monday through Friday 8:00 a.m. until 5:00 p.m. CST.
2.
Do not load wagon with more than 800 lbs.
3.
Do not allow children to use the wagon unsupervised. This Wagon is not a toy.
4.
Always distribute payload evenly over surface of bed.
5.
Do not load any items on top of the fence. Lower fence when objects are to be loaded onto the wagon.
6.
If any parts become damaged, broken or misplaced do not use the wagon until
replacement parts can be obtained.
7.
Do not operate or use on objects that can cause damage to the pneumatic tires or tubes.
Do not inflate tires more than 32 psi.
8.
SAVE THESE INSTRUCTIONS.
ASSEMBLY INSTRUCTIONS
Your Wagon requires assembly. Account for all parts and hardware before beginning assembly. If any parts are miss-
ing, damaged or if you have questions or need additional instructions
DO NOT RETURN THIS PRODUCT TO THE
RETAILER,
call the manufacturer at
1-800-304-1316
.
Tools required for assembly: Medium size slot screwdriver, 6, 8, and 12mm open end wrench and /or two medium
adjustable wrenches.
Refer to the exploded drawing and the parts list on the following
pages during assembly.
STEP 1
Assemble the REAR SUPPORT ASSEMBLY to the bed using
(4) 8 x 20mm Carriage Support Bolts, (2) 8 x 45mm Carriage
Support Bolts, and 6 - 8mm washers and lock nuts. Attach the
Rear Axle Support to the back of the bed using the (2) 8 x
45mm Carriage Support Bolts and then attach the Left and Right
Rear Axle Braces using the (4) 8 x 20mm Carriage Support
Bolts. Tighten all nuts securely.
STEP 2
The front support assembly is mostly pre-assembled at the factory.
Please make sure all bolts and nuts assembled at the factory are tight.
A.
Attach the Front Axle Support to the bed of the wagon using (2) 8 x 45mm Carriage
Support Bolts, 8mm washers and lock nuts.
B.
Secure the Center Front Axle Brace to the bed of the wagon using (2) 8 x 20mm
Carriage Support Bolts, 8mm washers and lock nuts.
STEP 3
Install the WHEELS in the following order.
A. Place the Wheel Spacer bushings onto the axles.
B. Place the Wheels onto the axles with the valve stem facing out.
C. Use the 12mm washers and the cotter pins to secure the wheels.
STEP 4
Attach the Pull Handle to the Front Axle Support using the
8 x 60mm Pull Handle bolt, 8mm washer and lock nut.
