13
ENGLISH
(Original instructions)
Troubleshooting
Problem
Possible cause
Possible solution
Tool will not start
Lock button not
pressed.
Press the lock button.
Battery not fitted
Fit the battery
Battery not charged
Charge the battery
Battery not fitted
corectly
Remove then re-fit the
battery
Chain does not stop
within 2 seconds
when the tool is
switched off
Chain tension is too
slack
Check chain tension
Bar/chain appear hot/
smoking
Oil tank empty
Check oil tank level
Oil hole blocked on
chain bar
Clean oil holes (21 - fig.
E) and clear the groove
around the edge of the
chainbar.
Chain tension is too
tight
Check chain tension
Guide bar sprocket
nose needs greasing
Oil the guide bar
sprocket nose
Chainsaw does not
cut well
Chain on backwards
Check/modify chain
direction
Sharpen
Chainsaw not using
oil
Debris in tank
Empty oil from tank and
replace
Oil hole in cap blocked
Remove debris from
hole
Debris in chain bar
Remove debris and
clean the chain bar
Debris in oil outlet
Remove debris
Chainsaw stops
suddnely during use
Battery depleted
Re-charge battery if
required.
Battery too hot
Leave the battery to
cool for atleast 30
minutes before
proceeding or charging.
Voltage limit protection
Restart the chainsaw.
Let the tool work at its
own pace. Do not
overload .
Maintenance
Regular maintenance ensures a long effective life for the tool.
We recommend you make the following checks on a regular
basis.
Warning!
Before performing any maintenance on power tools:
u
Switch off and disconnect the tool from the mains supply.
Oil level
The level in the reservoir should not be allowed to fall below
a quarter full.
Saw chain and guide bar
u
After every few hours of use and before storage, remove
the guide bar (7) and the saw chain (6) and clean them
thoroughly.
u
Make sure that the guard is clean and free from debris.
u
Oil sprocket nose and chain bar via the sprocket lubrica-
tion holes (21) (fig. E). This ensures an even distribution of
wear around the guide bar rails.
Saw chain sharpening
If you are to get the best possible performance from the tool it
is important to keep the teeth of the saw chain sharp.
Guidance for this procedure is found on the sharpener pack-
age.
Replacing worn out saw chains
Replacement saw chains are available through retailers or
Black & Decker service agents. Always use genuine spare
parts.
Saw chain sharpness
The saw chain cutters will blunt immediately if they touch the
ground or a nail while cutting.
Saw chain tension
Regularly check the saw chain tension.
What to do if your chainsaw needs repair.
Your chainsaw is manufactured in accordance with the rel-
evant safety requirements. Repairs should only be carried out
by a qualified person using original spare parts otherwise this
may result in considerable danger to the user. We recommend
you keep this user manual in a safe place.
Summary of Contents for GKC1825L20
