Black+Decker BDHR26K, Original Instructions Manual

7

ENGLISH

(Original instructions)

•  Insert the drill chuck (13) into the tool 

chuck (4) according to the instructions 

for installing attachments. Turn the drill 

chuck to loosen the clamps at the front 

-end of the drillclamp, and insert the 

accessory bar (14) into the clamps and 

turn the chuck in the opposite direction. 

You may also use the drill chuck key to 

tighten the clamp.

Hammer drilling (Fig. B)

•  For hammer drilling in masonry and 

concrete, set the operating mode 

selector (3) to the      position.

•  The drill bit has to be placed accurately 

onto the drill hole position. After that, 

pull the switch for optimal effects. Make 

sure the tool is in the correct position to 

prevent the drill from deviating from the 

hole.

•  When the drill hole is clogged with 

debris or fine powder, please don't exert 

any more pressure. Tool should be put in 

free-running state before removing part 

of the drill bit from the hole. If repeated a 

few times, the blockage in the hole 

would be cleared, and normal drilling can 

resume.

Only impact (Fig.B)

•  When chisel/peel/dismantle. turn the 

Mode selector (3) to “    ”. Need tip bid, 

cold chisel, scaling chisel and so on. 

Note: Don’t change the Mode selector 

when the tool is running.

•  Repeatly adjustment can position the 

Chisel Angle

Deflection angle (chisel/peel/dismantle) 

(Fig.G)

•  The drill head can fix different angles. 

Change the angle, turn the Mode selector 

(3) to “    ”. then turn the drill head to 

need angle.

Warning! 

When the drill bit hits cement or 

the steel rebar in the cement, the tool may 

recoil dangerously. Please hold the tool 

tightly in a balanced and stable position at 

all times to prevent it from recoiling 

dangerously.

Overload coupling device

If the drill bit his caught or hooked, the 

driving force transmitted to the drill shaft 

will be cut off. This would generate a strong 

recoil, so it would be necessary to hold the 

tool tightly with both hands to remain in a 

stable position.

Setting the drilling depth (Fig. E)

The depth stop is a convenient feature to 

ensure uniformity in drilling depth. Loosen 

the side handle to adjust the depth gauge 

according to the required depth. After that, 

tighten the side handle.

•  Slacken the side handle (5) by turning the 

grip counterclockwise.

•  Set the depth stop (6) to the required 

position. The maximum drilling depth is 

equal to the distance between the tip of 

the drill bit and the front end of the depth 

stop.

•  Tighten the side handle by turning the 

grip clockwise.

Switching on and off

Warning!

 Before plugging in to the power 

source, make sure the switch can be flipped 

freely, and can return to its original position 

once released.

•  To switch the tool on, press the variable 

speed switch (1). The tool speed depends 

on how far you press the switch.

•  As a general rule, use low speeds for 

large diameter drill bits and high speeds 

for smaller diameter drill bits.

•  For continuous operation, press the 

lock-on button (2) and release the 

variable speed switch.

•  To switch the tool off, release the variable 

speed switch. To switch the tool off when 

in continuous operation, press the 

variable speed switch once more and 

release it.

Accessories

The performance of your tool depends on 

the accessory used. BLACK+DECKER 

accessories are engineered to high quality 

standards and designed to enhance the 

performance of your tool. By using these 

accessories you will get the very best from 

your tool.